Artillery Sidewinder X1 Power Supply
2 disponibili
Replacement power supply for the Artillery Sidewinder X1. Replaces the original AC-to-DC unit that powers the mainboard, heaters, and motors to ensure stable operation.
Key Features
Compatibility: Artillery Sidewinder X1.
Function: Converts AC mains to the DC rail used by printer electronics.
Direct 1:1 replacement for failed, unstable, or noisy power units.
Match output voltage/current and DC connector type to the original label.
Uses the printer’s existing mounting points and wiring path.
Safety: disconnect from AC power before service; verify polarity and ground connection.
74,18€
2 disponibili
Un alimentatore sostitutivo identico per Sidewinder X1 che ripristina un’alimentazione CC stabile. Controllare l’etichetta originale per verificare che tensione, corrente e connettore corrispondano. Dopo l’installazione, eseguire un rapido test di calore/movimento.
Artillery Sidewinder X1 Power Supply
Based on 0 reviews
Be the first to review “Artillery Sidewinder X1 Power Supply”
You must be logged in to post a review.
Prodotti correlati
-
3D World, Filamenti & Resine 3D
Taulman t-glase PETT – 2.85mm – 450g – Black
Taulman3D has now released its low temperature, high strength industrial t-glase filament line into the desktop 3D printing community. T-glase, which is short for tough glass, is a specially engineered high strength industrial 3D printer filament for users that print with PLA or lower temperature desktop 3D Printers.
Features
Taulman t-glase is Manufactured in the U.S.A.
Very High Strength
Optimum printing temperature is about 235°C to 240°C, but will print down to 230°C and up to about 248°CSKU: 0634654248220 -
3D World, Filamenti & Resine 3D
PORO-LAY – GELLAY – 3.00mm – 0.25 kg
Gellay filament from the Porolay series is a very special material. With it, soft parts can be created and you can finally print out your organs from the 3D printer – of course not functional. But for e.g. aquaristics from the 3D printer, this gel-like printing material is very exciting. Like all other Porolay filaments, Gellay is also hard in its initial state and easy to print.
Main features
When wet: gel-like and very soft
In dry state: Stable, not elastic but bendable
Perfect for soft tissues
Low warpingSKU: 0634654248428 -
3D World, Filamenti & Resine 3D
PORO-LAY – LAYFOMM 60, 1.75mm, 0.25 kg
LAY-FOMM 60 is the newest innovation from the creator of LAYBRICK, LAYWOO-D3, and BendLay. LAY-FOMM 60 is a foamy material and is highly porous. LAY-FOMM 60 is part rubber-elastomeric polymer and part PVA. Once you rinse this material in water only the rubber polymer remains as your micro-porous and flexible object. LAY-FOMM 60 is slightly firmer than LAY-FOMM 40.
Main features
After printing rinse with water to create an object that is micro-porous & elastic
Optimal for printing soft rubber objects
All objects are hot-sealable after drying
the objects have near zero warp (deformation while printing)SKU: 0634654248398
There are no reviews yet.