CreatBot DE / DX Heat Bed Connector
4 disponibili
Replacement heat bed connector/cable for CreatBot DE and DX printers. Provides the high-current connection to the heated build plate and, where applicable, routes the bed temperature (thermistor) signal for stable heating control.
Key Features
Compatibility: CreatBot DE / DX heat bed connection points.
Function: Carries bed heater power and (where applicable) the thermistor/temperature signal.
Pre-terminated plug set matching the factory harness for plug-and-play service.
Direct 1:1 replacement for burnt, loose, or intermittent connectors.
Designed for correct routing and strain relief to reduce flex and heat stress.
Safety: power off and allow the bed to cool; verify polarity, latch engagement, and secure wiring.
7,09€
4 disponibili
Un gruppo connettore/cavo per il letto riscaldato CreatBot DE/DX che ripristina un feedback affidabile di potenza e temperatura. Ideale quando l’originale presenta scolorimento, scioglimento o riscaldamento intermittente. Dopo l’installazione, eseguire un test termico del letto e confermare le letture della temperatura.
CreatBot DE / DX Heat Bed Connector
Based on 0 reviews
Be the first to review “CreatBot DE / DX Heat Bed Connector”
You must be logged in to post a review.
Prodotti correlati
-
3D World, Filamenti & Resine 3D
PORO-LAY – LAYFOMM 40, 3.00 mm, 0.25 kg
LAY-FOMM 40 is the newest innovation from the creator of LAYBRICK, LAYWOO-D3, and BendLay. LAY-FOMM 40 is a foamy material and is highly porous. LAY-FOMM 40 is part rubber-elastomeric polymer and part PVA. Once you rinse this material in water only the rubber polymer remains as your micro-porous and flexible object.
Main features
After printing rinse with water to create an object that is micro-porous & elastic
Optimal for printing soft rubber objects
Polymer components of LAY-FOMM 40 are harmless and foodsafe.
All objects are hot-sealable after dryingSKU: 0634654248381 -
3D World, Filamenti & Resine 3D
PORO-LAY – GELLAY – 3.00mm – 0.25 kg
Gellay filament from the Porolay series is a very special material. With it, soft parts can be created and you can finally print out your organs from the 3D printer – of course not functional. But for e.g. aquaristics from the 3D printer, this gel-like printing material is very exciting. Like all other Porolay filaments, Gellay is also hard in its initial state and easy to print.
Main features
When wet: gel-like and very soft
In dry state: Stable, not elastic but bendable
Perfect for soft tissues
Low warpingSKU: 0634654248428
There are no reviews yet.