Raise3D Heater Rod Power Supply Cable
6 disponibili
Replacement power supply cable for the Raise3D heater rod (hotend heater cartridge). Provides the high-current DC path from the control/power output to the heater rod for stable heating performance.
Key Features
Compatibility: Raise3D printers using a heater rod in the hotend (match connector type and length to your original).
Function: Supplies regulated DC power to the heater cartridge from the board/PSU output.
Direct 1:1 replacement with factory-style, keyed connectors—no soldering required (variant-dependent).
High-temperature insulation and strain relief suited for toolhead motion.
Restores reliable preheat and temperature stability when original wiring is worn or intermittent.
Installation tip: power off; route away from sharp edges and moving belts; keep separate from thermistor leads; verify connector orientation and run a preheat test.
0,00€
6 disponibili
Cavo sostitutivo specifico per il modello che alimenta l’asta del riscaldatore dell’hotend Raise3D. Abbina il connettore e la lunghezza all’originale, installalo con l’alimentazione spenta ed esegui un breve preriscaldamento per confermare un riscaldamento stabile.
Raise3D Heater Rod Power Supply Cable
Based on 0 reviews
Be the first to review “Raise3D Heater Rod Power Supply Cable”
You must be logged in to post a review.
Prodotti correlati
-
3D World, Filamenti & Resine 3D
NinjaFlex Filament – 1.75mm – 0.5 kg – Sapphire Blue
Open a world of possibilities, limited only by your imagination. NinjaFlex, a cutting-edge filament for 3D printers, is a specially formulated thermoplastic elastomer (TPE) that produces flexible prints with elastic properties. Patent pending technology allows for smooth feeding and clean, high-quality printed parts.
Features
Consistent diameter and material properties provide reliable, high quality prints
Patent pending technology allows for smooth feeding
High elasticity and excellent abrasion resistance
Excellent build platform adhesion and bonding between layersSKU: 0662345233644 -
3D World, Filamenti & Resine 3D
PORO-LAY – GELLAY – 1.75mm – 0.25 kg
Gellay filament from the Porolay series is a very special material. With it, soft parts can be created and you can finally print out your organs from the 3D printer – of course not functional. But for e.g. aquaristics from the 3D printer, this gel-like printing material is very exciting. Like all other Porolay filaments, Gellay is also hard in its initial state and easy to print.
Main features
When wet: gel-like and very soft
In dry state: Stable, not elastic but bendable
Perfect for soft tissues
Low warpingSKU: 0634654248411
There are no reviews yet.